The iPC-I XC16/PMC Intelligent board for 5 V and 3.3 V PMC bus systems with high/low-speed CAN interface and LIN interface Covering a wide range of industrial and automotive CAN applications, this is a powerful and economic solution for an active CAN board with one or two CAN channels. The interface is state-of-the-art, supports PMC and can be easily installed by Plug & Play. Some of the features offered by the on-board microcontroller include filtering, pre-processing, transmission and time-stamped storage of the CAN messages. Due to the powerful microcontroller, both CAN controllers can operate simultaneously without losing any data even in systems with a high bus load. In combination with the VCI CAN driver, the iPC-I XC16/PMC allows the seamless integration of PC-supported CAN applications.
| PC bus interface |
PMC Bus (2.2), 32 Bit / 33 MHz, 5 Volt or 3.3 Volt |
| Memory range |
Plug & Play, 16 kB memory mapped and 128 bytes I/O area |
| Interrupts |
INT A, Plug & Play |
| Microcontroller |
Infineon XC161, 40 MHz |
| On board memory |
512 kByte SRAM, 128 kByte FLASH, 8 kByte DPRAM |
| CAN controller |
TwinCAN (two CAN channels) |
| CAN bus interface |
ISO 11898-2 and ISO 11898-3, Sub D9 connector according to CiA 303-1, galvanic decoupled and high-/low-speed bus interface switchable via software |
| LIN controller |
TJA1020 |
| LIN bus interface |
ISO 9141/LIN, Master/Slave mode switchable via software, galvanic isolation |
| Power supply |
5 V DC, 100 mA typ.; 3.3 V DC, 120 mA typ. |
| Temperature range |
-20 ºC ... +70 ºC |
| Certification |
CE, FCC |
| Size |
Approx. 74 x 149 mm single CMC |
|
